ProRestore ELECTRO-GEN Betreibershandbuch PDF herunterladen (Seite 12)

WInTeRIZInG

Protect unit utilizing water based formulations from freezing if unit is to

be transported, or stored in an area where freezing is likely. Drain solu-

tion reservoir, and spray some winterized windshield cleaning solution

through unit. Solvent based formulations such as ODORx

THERMO 55

™

do not freeze, so when utilizing solvent based formulations no special

winterizing procedure is necessary.

CloGGInG

Foreign matter in the liquid can result in clogging the pump or nozzle.

To insure proper operation it is recommended that clean formulation

always be utilized, or that it should rst be ltered through paper coffee

lters before use if foreign matter is present or suspected.

Replace nozzle every 8 hours of operation to insure small fog particle size.

PRessURe PURGInG THe MeCHanIsM

Aerosol solvent carburetor cleaner may be used to purge and ush dirty

or clogged pump mechanisms, or for periodic maintenance.

Note: Unit's motor must make normal buzzing sound for this maintenance/

repair technique to be effective.

1. Protect work area from solvent related damages by covering with

newspaper or other absorbent material.

2. Wear protective goggles and rubber gloves.

3. Insert the plastic tube from the aerosol carburetor cleaner into the

can nozzle.

4. Remove formulation reservoir from fogger.

5. Remove formulation lter from brass stem.

6. Disengage heat barrel from fogger. Plug fogger into electrical outlet.

7. Insert straw from aerosol can into white plastic nut at bottom of brass stem.

8. Simultaneously pull trigger on fogger while depressing spray nozzle

on aerosol can to inject a 1 second burst of cleaner into the mecha-

nism to purge and ush system. A stream or spray of cleaner should

be visible at nozzle cap.

9. Fill formulation reservoir with suitable solution, clean formulation lter

and re-install on brass stem, attach formulation reservoir to unit and test operate.

If necessary, repair or replace pump/piston system.

1 2 ... 7 8 9 10 11 12 13 14 15

Keine Kommentare

ProRestore ELECTRO-GEN Betreibershandbuch Seite 12